Furnace Replacement Antelope CA With a Written Quote
A new furnace sized and vented correctly by a licensed, insured local crew. You get a written quote and a permit pulled on every replacement.
- Load check before any quote
- Options in writing, from 80 percent furnaces to heat pumps
- County permit and final inspection handled for you
Matching a New Furnace to Your Home
Furnace replacement Antelope CA homeowners need means a load check, a written quote for an 80 or 90 percent gas furnace or a heat pump, a Sacramento County permit and a safe install with new venting where needed. Most new furnaces here run about $3,500 to $7,500 installed.
That mix of options is why we start with your home instead of a catalog. This page is for homeowners facing a failed furnace, and for owners of older units who want furnace installation Antelope crews can price clearly before the heat quits.
What a Furnace Replacement Includes
A complete job covers more than swapping the cabinet. Here is what a proper furnace replacement covers.
- Visit and checks: The tech visits your home, runs a load check and inspects the ducts before quoting.
- Written options: You see clear choices, including an 80 percent furnace, a 90 percent furnace and a heat pump.
- Permit and removal: We pull the county permit and remove the old furnace.
- Install and venting: The new furnace is set, vented and connected, with a gas line test after.
- Safety tests: We run a carbon monoxide and draft test, set up the thermostat and schedule the county final.
Why Antelope Furnaces Reach Replacement Age
Many local homes were built decades ago, and the way they were built affects what a replacement needs.
- Original equipment: Many homes still run the late 1980s or 1990s furnace that came with the house.
- Attic furnace replacement: Attic installs need careful venting and drain planning, so the install is more than a straight swap.
- Mild winters: An 80 percent furnace often pays back better than a 90 percent furnace in an attic, since gas savings are small.
- Duct condition: Old furnaces often feed old ducts, and replacement day is the right moment to spot leaks, crushed runs and weak airflow.
- Tight closets and garages: Garage and closet installs have limited room, so clearances, combustion air and drain routes are planned before the old unit comes out.
How a Furnace Swap Gets Done
Every replacement follows the same seven steps. You know the schedule before we start, and the price is in writing before we order equipment.
- Home visit: A tech measures, checks the ducts and looks at the venting, then asks how you use the home.
- Written quote: You get equipment options and prices in writing, with no pressure to decide that day.
- Scheduling: Once you pick, we set an install date that suits you and order the furnace.
- Permit: We pull the Sacramento County mechanical permit before the work begins.
- Install day: Most furnace swaps take about a day, depending on venting and access.
- Testing: We test the gas line, venting, draft and carbon monoxide levels, then run the furnace through a full cycle.
- County final and warranty: The county inspector gives final approval, and we register the warranty and hand you the paperwork.
80 vs 90 Percent Furnace and Other Options
If you are comparing high efficiency furnace install Antelope quotes, here is how the options differ in plain words.
80 Percent Furnaces
These vent through a metal flue and are common in older homes. They cost less up front, and in mild winters the gas savings from higher efficiency models are small.
90 Percent Plus Furnaces
These capture more heat from the gas and vent through plastic pipe. They need a condensate drain, which adds work in attics and garages.
Single Stage and Two Stage
Single stage furnaces run at full output. Two stage models run lower most of the time, which gives steadier temperatures and quieter operation.
Variable Speed Blower and Dual Fuel
A variable speed blower moves air more quietly. Dual fuel systems pair a heat pump with a gas furnace so the furnace backs up the heat pump.
What Does a New Furnace Cost in Antelope?
If you are asking about a new furnace cost Sacramento homeowners can expect, the answer depends on efficiency, size and venting. These are typical ranges. They are not quotes, and you get a written price after a home visit.
| Option | Typical range |
|---|---|
| 80 percent furnace | $3,500 to $5,500 |
| 90 percent plus furnace | $4,500 to $7,500 |
| Furnace plus AC | $8,000 to $14,500 |
| Permit plus HERS test | $250 to $700 |
For affordable furnace replacement Antelope buyers often compare an 80 percent and a 90 percent model side by side, and we show the math in writing.
Heat Pump or New Furnace for Your Home?
If your AC is also over 12 years old, a heat pump can replace both systems. SMUD pays up to $3,000 to switch from gas, though that rebate is for qualifying heat pump conversions and not for new gas furnaces. If your AC is new, a furnace replacement often makes more sense. We price both so you can compare, and we explain what each choice means for your gas bill, your SMUD bill and your comfort in July.
Recent Furnace Swaps Around Antelope
We have replaced furnaces across Antelope and nearby neighborhoods, from attic furnaces in older homes to two stage models paired with a new AC. Each job ended with a passed inspection and a walkthrough.
Services That Pair With a New Furnace
A new furnace often goes with other work. These related services come from the same crew.
- Furnace repair when the unit may still be worth fixing
- Heat pump installation for homes leaving gas behind
- Full HVAC replacement when the AC and furnace are both aging
- Our heating hub for the full list of heating services
Furnace Installs Across Antelope and Nearby
We handle furnace replacement 95843 homeowners ask about, from Antelope Pointe to Lakes at Antelope. If you searched furnace replacement near me, call and we will set a time for the home visit. Need same day furnace replacement Antelope families sometimes ask for in a breakdown? Call early, and we will tell you what the schedule allows.
Our crew also covers furnace replacement Roseville homeowners need, furnace replacement Roseville CA jobs, furnace replacement Citrus Heights CA and furnace replacement North Highlands installs. People ask who offers the best furnace replacement in Antelope, and our answer is simple: the crew that shows the math.
Furnace Replacement Questions Answered
Wondering when to replace a furnace? These answers start with the facts.
How much does a new furnace cost in Antelope?
Most new gas furnaces here run about $3,500 to $7,500 installed, depending on efficiency, size and venting. Pairing it with a new AC costs more. We give a written quote after a home visit.
Is a 90 percent furnace worth it in Antelope?
Often not on its own. Winters are mild, so the gas savings are small, and attic installs add drain work. An 80 percent furnace or a heat pump is usually the better value here. We show the math.
When should I replace my furnace?
Replace it if it is over 20 years old, has a cracked heat exchanger, needs a repair over half the cost of a new one or keeps failing. If your AC is old too, look at a heat pump.
Call Today for Furnace Replacement Antelope CA
Call (279) 258-6090 and ask for a home visit and a written quote. We ask a few quick questions, share a typical price range and set a time window. A licensed, insured tech arrives, checks your venting and ducts and gives you clear options before you commit to anything.
All diagnostic procedures, Title 24 compliance details, SMUD rebate specifications, and equipment guidelines on this page adhere to California CSLB C-20 mechanical contractor standards and EPA Section 608 refrigerant regulations.
Furnace Replacement and Installation Dispatch Coverage & Service Area Map
Centrally dispatched from Elverta Road in Antelope, providing rapid response across Sacramento and South Placer County.