Heat Pump Installation Antelope CA Done Right
A new heat pump sized with a load calculation by a licensed, insured local crew. You get a written quote with rebate options first.
- Load calculation and duct check before any quote
- County permit and HERS test handled for you
- Rebate paperwork prepared if you qualify
Sizing, Permits and Rebates in One Plan
Heat pump installation Antelope CA starts with a load calculation, a duct check and a written quote with rebate options. We install, test the charge and airflow, set up the Wi Fi thermostat SMUD requires and pull the county permit. A full ducted system here usually runs about $6,200 to $15,200 before rebates.
This page is for homeowners replacing an old AC, an old furnace or both. If your home was built in the 1980s or 1990s, as most Antelope homes were, a heat pump can replace the pair with one system.
What a Heat Pump Installation Includes
A proper install covers far more than setting a box outside. Here is what is in the job from first visit to final approval.
- Visit and load calculation: The tech inspects the home and runs a Manual J calculation to size the system.
- Duct and electrical check: We look at duct condition, panel space and breaker size before quoting.
- Written options: You see equipment choices with rebate math, so the price is clear before you decide. We also explain the monthly bill impact in plain terms.
- Permit and install: We pull the county permit, set the equipment, then vacuum the lines and set the charge.
- Old equipment removal: The old outdoor unit and any refrigerant are removed and handled by the book, so you do not have to arrange disposal.
- Testing and thermostat: Airflow is tested and the Wi Fi thermostat is set up.
- HERS and final: A HERS rater tests the install, the county inspector signs off and we file the rebate paperwork.
Why Antelope Homes Suit Inverter Heat Pumps
Local weather and local houses both point toward efficient electric heating and cooling. These are the reasons we see.
- Mild winters and hot summers: One variable speed unit can handle 100 F afternoons and frosty mornings without strain.
- SMUD time of day pricing: Weekday evenings from 5 to 8 p.m. cost more, and an efficient unit uses less power in that window.
- Electric ready homes: Many Antelope homes already have a 240 volt circuit and space in the panel, which can keep electrical costs low on a swap.
- 1990s ducts: Many homes have leaky attic ducts that waste a new system’s output, so we check them during the visit.
From First Call to Final Inspection
Every installation follows the same seven steps. You know the schedule before we start, and the price is in writing before equipment is ordered.
- Home visit: A tech measures the home, checks the ducts and panel, then asks how you use each room.
- Written quote: You get options and prices in writing, with rebate details and no pressure to decide that day.
- Scheduling: After you choose, we book an install date and order the equipment.
- County permit: We pull the Sacramento County permit before work begins.
- Install day: Most installs take one to two days, depending on ducts, electrical work and access.
- HERS test and county final: A rater tests the system and the county inspector gives final approval.
- Rebate filing and walkthrough: We file the rebate paperwork and walk you through the thermostat and filter.
Heat Pump Systems We Install
The right system depends on your home, your ducts and your rebate goals. Here are the main choices.
Ducted Variable Speed Systems
A variable speed heat pump install is the top rebate tier. The compressor adjusts its speed, so the home stays steadier and the unit runs quietly.
Two Stage Systems
Two stage models run on low most of the time and step up on the hottest or coldest hours. They qualify for a mid level rebate if they meet 15.2 SEER2.
Dual Fuel Systems
A dual fuel heat pump pairs a heat pump with your existing gas furnace. The furnace covers the coldest nights, which suits homes that want to keep gas.
Heat Strips and Backup Heat
Electric heat strips sit inside the air handler and add warmth on the coldest nights. We size them to your home, so you get steady heat without running the strips more than needed.
Air Handlers and Ductless Units
An air handler with heat strips fits homes without a furnace. Ductless mini splits suit additions and rooms that have no ducts.
How Much Does Heat Pump Installation Cost in Antelope?
If you are asking about heat pump install cost Sacramento homeowners pay, the answer depends on size, efficiency and electrical work. These are typical ranges before rebates. They are not quotes, and you get a written price first.
| Item | Typical range before rebates |
|---|---|
| Ducted heat pump system | $6,200 to $15,200 |
| Dual fuel system | $9,000 to $16,000 |
| Panel or circuit work, if needed | $300 to $2,500 |
| Permit plus HERS test | $250 to $700 |
SMUD may take up to $3,000 off when you switch from gas and qualify, and up to $1,000 for electric to electric upgrades. For affordable heat pump installation Antelope buyers can plan around, we show the rebate math in writing.
What Size Heat Pump Do I Need?
People ask us this more than anything else, and the answer is not square feet. A Manual J load calculation looks at windows, insulation, ducts and how the home faces the sun.
- Oversized units short cycle: They start and stop often, wear faster and leave rooms muggy.
- Undersized units struggle: They run nonstop on 105 F afternoons and still fall behind.
- Ducts count too: A right sized unit on leaky ducts will still miss its goal, so we inspect the attic.
- Room by room checks: We note hot upstairs rooms and cold garages that change the plan.
A load calculation takes extra time on the visit, but it protects you from paying for a unit that is too big or too small.
Recent Heat Pump Installs Around Antelope
We have installed heat pumps across Antelope and nearby neighborhoods, from a variable speed system in a two story home to a dual fuel setup for a family that kept its gas line. Each job ended with a passed inspection and a walkthrough of the thermostat, the filter and what to expect on your first SMUD bill.
Services That Pair With a New Heat Pump
A new heat pump often goes with other work. These related services come from the same crew.
- Heat pump services for the full picture of repair and installs
- Gas to electric conversion for homes leaving gas behind
- Ductless mini split installation for rooms without ducts
- Duct repair and sealing for leaky attic runs
- Smart thermostat installation for the SMUD requirement
Heat Pump Installs Across Antelope and Nearby
We handle heat pump installation 95843 homeowners ask about, from Antelope Meadows to Lakes at Antelope. If you searched heat pump installation near me, call and we will set a time for the home visit. Need same day heat pump installation Antelope buyers sometimes ask for after a failed system? Call early, and we will tell you what the schedule allows.
Our crew also covers heat pump installation Roseville CA, heat pump installation Citrus Heights CA and heat pump installation North Highlands jobs. Looking for a heat pump installer Roseville homeowners can reach? We check what your utility offers first, since SMUD rebates may not apply there.
Heat Pump Installation Questions Answered
People ask who offers the best heat pump installation in Antelope, and our answer is simple: the crew that sizes the system and shows the math. If you are comparing a SMUD approved heat pump installer, ask for proof of SMUD Contractor Network status. These answers start with the facts.
How much does a heat pump cost to install in Antelope?
A full ducted system usually runs about $6,200 to $15,200 before rebates, depending on size, efficiency and ductwork. SMUD can take up to $3,000 off if you are switching from gas and qualify.
Do I need a new electrical panel for a heat pump?
Many homes need no new panel. They already have a 240 volt circuit from the old AC. If you are dropping gas heat, heat strips may need more capacity. We check your panel on the visit before quoting.
How long does a heat pump installation take?
Most installs take one to two days. Extra electrical work or duct repairs can add time, and the permit, HERS test and county final happen on separate days. We give you a schedule up front, so you can plan around the work and arrange for pets and parking.
Is a heat pump replacement in Antelope worth doing now?
If your AC and furnace are both near the end of their life, often yes. One system replaces two, and SMUD rebates lower the cost. If your AC is new, we price a furnace swap beside it. Heat pump replacement Antelope owners choose usually comes down to age and bills.
Call Today for Heat Pump Installation Antelope CA
Call (279) 258-6090 and ask for a home visit and a written quote. We ask a few quick questions, share a typical price range and set a time window. A licensed, insured tech arrives, sizes the system with a load calculation and gives you clear options before you commit to anything.
All diagnostic procedures, Title 24 compliance details, SMUD rebate specifications, and equipment guidelines on this page adhere to California CSLB C-20 mechanical contractor standards and EPA Section 608 refrigerant regulations.
Heat Pump Installation Dispatch Coverage & Service Area Map
Centrally dispatched from Elverta Road in Antelope, providing rapid response across Sacramento and South Placer County.